• Power-Managed modes:

- Run: CPU on, peripherals on

- Idle: CPU off, peripherals on

- Sleep: CPU off, peripherals off

• Two-Speed Oscillator Start-up

• Fail-Safe Clock Monitor

• Power-Saving Peripheral Module Disable (PMD)

• Ultra Low-Power Wake-up

• Fast Wake-up, 1 s Typical

• Low-Power WDT, 300 nA Typical

• Ultra Low 50 nA Input Leakage

• Run mode Currents Down to 5.5 A, Typical

• Idle mode Currents Down to 1.7 A Typical

• Sleep mode Currents Down to Very Low 20 nA, Typical

• RTCC Current Downs to Very Low 700 nA, Typical

Special Microcontroller Features:

• Operating Voltage Range: 1.8V to 5.5V

• On-Chip 3.3V Regulator

• Operating Speed up to 64 MHz

• Up to 128 Kbytes On-Chip Flash Program Memory

• Data EEPROM of 1,024 Bytes

• 4K x 8 General Purpose Registers (SRAM)

• 10,000 Erase/Write Cycle Flash Program Memory, Minimum

• 1,000,000 Erase/write Cycle Data EEPROM Memory, Typical

• Flash Retention: 40 Years, Minimum

• Three Internal Oscillators: LF-INTRC (31 kHz), MF-INTOSC (500 kHz) and HF-INTOSC (16 MHz)

• Self-Programmable under Software Control

• Priority Levels for Interrupts

• 8 x 8 Single-Cycle Hardware Multiplier

• Extended Watchdog Timer (WDT):

- Programmable period from 4 ms to 4,194s (about 70 minutes)

• In-Circuit Serial Programming™ (ICSP™) via Two Pins

• In-Circuit Debug via Two Pins

• Programmable: - BOR - LVD

Peripheral Highlights:

• Up to Ten CCP/ECCP modules:

- Up to seven Capture/Compare/PWM (CCP) modules

- Three Enhanced Capture/Compare/PWM (ECCP) modules

• Up to Eleven 8/16-Bit Timer/Counter modules:

- Timer0 – 8/16-bit timer/counter with 8-bit programmable prescaler

- Timer1,3 – 16-bit timer/counter - Timer2,4,6,8 – 8-bit timer/counter - Timer5,7 – 16-bit timer/counter for 64k and 128k parts

- Timer10,12 – 8-bit timer/counter for 64k and 128k parts

• Three Analog Comparators

• Configurable Reference Clock Output

• Hardware Real-Time Clock and Calendar (RTCC) module with Clock, Calendar and Alarm Functions

• Charge Time Measurement Unit (CTMU):

- Capacitance measurement for mTouch™ sensing solution

- Time measurement with 1 ns typical resolution

- Integrated temperature sensor

• High-Current Sink/Source 25 mA/25 mA (PORTB and PORTC)

• Up to Four External Interrupts

• Two Master Synchronous Serial Port (MSSP) modules:

- 3/4-wire SPI (supports all four SPI modes)

- I2C™ Master and Slave modes

• Two Enhanced Addressable USART modules:

- LIN/J2602 support - Auto-Baud Detect (ABD)

• 12-Bit A/D Converter with up to 24 Channels:

- Auto-acquisition and Sleep operation

- Differential input mode of operation

• Integrated Voltage Reference